Showing posts with label body cart. Show all posts
Showing posts with label body cart. Show all posts

Saturday, July 7, 2018

Surprises can be compelling

I got the pan down, removed the shift rod and, while I was at it, took some pictures for, uh, posterity.

From far away, the pan doesn't look that bad.
 Rear left side - no rust through but it's dented up real good.  This kick panel bracket is in nice shape and still attached to the pan.
 Rear right side - rust through along with some red crap slathered on it.  Lots of holes covered up by the red stuff.  Lots of dents as well.
 Front part is decent but has lots of dents/creases that don't show up very well in pictures.
Rear right kick panel bracket - not much left and it's not touching the pan.
The body is in rather nice shape - no real rust to speak of and it's clean.
Underside of the rear right corner - a little rust on the body side but the contact surface with the pan is in great shape with no gaping rust issues.
 Rear left side is very clean
Right front - again, clean but has some rust to be dealt with.  Seems the right side of the body took the brunt of the rust issues.
 Left front looks pretty good!
 Left front - again, very clean.
 Right front is looking nice here.
Now would be the time to do any of the under dash wiring...but, alas, I don't have anything that needs to be done, short of figuring out why the horn didn't work (and that doesn't work without the pan).
The order of hardware arrived today - just in time!

The engine is possibly getting picked up on Tuesday to begin the tear down and rebuild process.  I'm VERY curious about what will be found inside.

Friday, July 6, 2018

The night's just long enough for me to build it all and let it fall apart

Today's goal was to build the body cart, get the body on the cart and drop the pan.

I was able to cheat slightly - my kid wanted to build something and it was just too perfect so we cut all of the pieces and built a large part of the cart the previous evening.

All I had to do today was install the caster wheels and figure out how to get the body on it without destroying my back or having the car fall on me.  When you have to do stuff solo, you get creative...sparing any incriminating details, the body made it on the cart, I'm fine and there are no pictures of the process.
I used a couple of extra shelving pieces to make ramps to slide the pan out from under the body.

Next step was to remove everything from the pan, bag and tag it and get it ready for transport.  I spent the better part of an hour scraping all of the tar board off of the pan and tunnel, removing heater system cables and all of the remaining brake lines and related grommets.
 Having a place to store the pan that wouldn't also double as a hazard to the kid meant that I'd spend the better part of three hours rearranging the garage to store everything so that it might no get moved around much but still be ready to be installed when the time comes.

I took several pictures of the bottom of the pan but, for some reason, none of the top side.  It's also at this time that I realized that I forgot to remove the shift rod - so that's going to have to come out before it goes off for work.
 Once I got this thing off of the body - I looked it over to determine if I should reconsider the quarter pan idea.  The front area is pretty decent and only the passenger's side rear area is bad - but the whole thing is dented/creased to shit from all of the dirt roads this car has likely seen in the early parts of its life.  Up near the front heater outlet, there's a slight crease in the floor that's about 18" long - among a handful of other areas.
The passenger's side rear seat foot well and battery area are mostly Swiss cheese and barely together.

Full pans it is...now I have to decide if I'm reinstalling jack points and then find some.

I've now got the weekend to relax and figure out what the next steps will be going forward.